Cargando…
Manufacturing science and materials engineering : selected, peer reviewed papers from the 2010 International Conference on Manufacturing Science and Materials Engineering (ICMSME 2011), October 14-15, 2011, Shanghai, China /
The 2011 International Conference on Manufacturing Science and Materials Engineering (ICMSME 2011) was held on October 14-15th, 2011, in Shanghai. The proceedings of the conference serve as a vehicle for the rapid dissemination of original theoretical and applied research results which will be of pe...
| Clasificación: | Libro Electrónico |
|---|---|
| Autor Corporativo: | |
| Otros Autores: | |
| Formato: | Electrónico Congresos, conferencias eBook |
| Idioma: | Inglés |
| Publicado: |
Durnten-Zurich, Switzerland :
Trans Tech Publications,
©2012.
|
| Colección: | Advanced materials research ;
v. 443-444. |
| Temas: | |
| Acceso en línea: | Texto completo |
Tabla de Contenidos:
- Manufacturing Science and Materials Engineering; Preface and Organizing Committee; Table of Contents; Chapter 1: Advances in Manufacturing Engineering Techniques and Materials Science; The Research on Applying High Precision Ultrasonic Ranging in the Auto-Levelling System of Paver; Modeling Hot Rolling Based on RBF Neural Networks and Thermo-Mechanical Coupling FEM; Prediction of Settlement of Soft Clay Foundation in Highway Using Artifical Neural Networks; Influence of Cutter Geometric Parameters on the Stability of Milling Process of Thin-Walled Blades.
- Identification of Natural Frequency of Bearing Rotor Based on GA-SVMConcrete Compressive Strength Prediction Using Rebound Method with Artificial Neural Network; Fiber Grating Sensor Temperature Prediction Based on Relevance Vector Machine; Influence of Inner Rubber Bushing Stiffness of the Lateral Rod on Rear Multi-Link Suspension Performance; Approach to Detect Air Tightness of Engine Cylinder by Vibration Analysis; Studies on Solar Drying of Oily Sludge; Design and Modeling of Cutting Paper Tape Machine for Sole Coating; GA-BP Neural Network Based Tire Noise Prediction.
- FLI Co-Simulation Applied and Realized in Rail Profile Automatic Detection SystemMicro-Image with Photo-Acid Generator Polymer Nano Sheet; Dynamic Prediction Model for Rolling Bearing Friction Torque Using Grey Bootstrap Fusion Method and Chaos Theory; Evaluation of Tapered Roller Bearing Vibration Velocity as Data Series Using Grey System Theory; The Research on the Flexible Integrated Research Platform of the Solar Energy Photovoltaic System; The New Rural Residential Building Materials of Low Carbon Mode of Thinking; Resonance Frequency Detection System of Piezoelectric Micro-Cantilever.
- Design and Implementation of Integrated Case Packer Based on High Speed Pick-and-Place RobotThe Influence of Cutting Parameters on Machined Surface Microhardness during High Speed Milling of Titanium Alloy TC17; The Effect of Cutting Parameters on Machined Surface Microstructure during High Speed Milling of Titanium Alloy TC17; Numerical Analysis of Submerged Pipelines for Deep Water S-Lay; MEMS Gyro Aided Calibration of Electronic Compass; High Accuracy AMR Magnetometer and its Application to Vehicle Detection.
- The Application of Linear Variable Filter to Improve the Resolution of Micro Spectrometer SystemsThe Study of Residual Stresses in High-Speed Milling of Titanium Alloy TC11; Application of Constant Modulus Algorithm on the Civil Aviation VHF Radio Interference Suppression; Research on the Mathematics Model of a Permanent Magnet Linear Oscillatory Actuator with Moving Iron and Non-Salient Pole; Flapping Wing Micro Aerial Vehicle Attitude Control with Fuzzy Sliding Mode Controller Based on RBF Neural Network.