Cargando…
Problems of Emergency Situations : Materials and Technologies II Selected, peer-reviewed papers from the International Scientific Applied Conference "Problems of Emergency Situations" (PES 2021), May 20, 2021, Kharkiv, Ukraine
This volume contains papers presented at the International Scientific Applied Conference "Problems of Emergency Situations" (PES 2021, May 20, 2021, Kharkiv, Ukraine). The purpose of the conference was to discuss issues related to the problems and prospects of the introduction of the lates...
| Clasificación: | Libro Electrónico |
|---|---|
| Autores Corporativos: | , |
| Otros Autores: | |
| Formato: | Electrónico Congresos, conferencias eBook |
| Idioma: | Inglés |
| Publicado: |
Zurich :
Trans Tech Publications, Limited,
2021.
|
| Colección: | Materials science forum ;
v. 1038. |
| Temas: | |
| Acceso en línea: | Texto completo |
Tabla de Contenidos:
- Intro
- Problems of Emergency Situations: Materials and Technologies II
- Preface
- Table of Contents
- Chapter 1: Properties and Processing Technologies of Structural Metals
- Low Cycle Fatigue of Structural Alloys
- Planning an Experiment for Low-Cycle Fatigue under Conditions Deep Cooling
- Repeatability of Sheet Material Formation Results and Interchangeability of Processing Modes at Multi-Pass Laser Formation
- Stress-Strain State and Structural-Phase Transformations of Metal Articles Obtained by Laser Shaping
- Investigation of the Properties of Powder Materials Using Computer Modeling
- Analysis of the Effect of Mechanical Oscillations Generated during Welding on the Structure of Ductile Constituent of Products Made of Steel 10G2FB
- Chapter 2: Coatings and Surface Treatment
- Electrochemical Synthesis of Crystalline Niobium Oxide
- Research of the Influence of Silicate Fillers on Water Absorption and Microstructure of Styrene-Acrylic Dispersion Coatings
- Alternative Strengthening of Jewelry Tools Using Chemical-Thermal and Local Surface Treatments
- Electrochemical Formation of Oxide Films on the Titanium Alloy of Ti6Al4V in Ethylene Glycol-Water Electrolytes to Produce Bioinert Coatings and Increase the Corrosion Resistance of Medical Implants
- Research of the Microstructure of the Deposited Layer during Electric Arc Surfacing with Control Impacts
- Application of Thermo-Frictional and Chemical-Thermal Methods Treatments for Surface Strengthening of Materials
- Investigation of the Heat-Affected Zone Properties During Cladding of Power Equipment with Austenitic Materials Using Control Mechanical Impacts on the Strip Electrode
- Studying the Effect of Fuel Elements Structural Materials Corrosion on their Operating Life
- Chapter 3: Polymers and Composites
- Research of Safe Technology of Impregnation of Heated Reinforcing Materials with Binder
- Use of Silicone Materials in Modern Structures of Highly Functional Technical Means of Rehabilitation
- The Thermal Destruction and Coke Formation Intensity Influence on the Delamination and Destruction of Fiber Reinforced Plastics with a Unidirectional Filler under High Temperature Conditions
- The Deformable and Strength Characteristics of Nanocomposites Improving
- Experimental Substantiation of Antimicrobial Efficiency of a New Composite Polymeric Material Based on Poly(2-Hydroxyethyl Methacrylate) under the Action of Low-Intensity Current without External Power Supplies
- An Experimental Study on Elastic and Strength Properties of Addictively-Manufactured Plastic Materials
- Sorption Resistance Studying of Environmentally Friendly Polymeric Materials in Different Liquid Mediums
- Chapter 4: Functional Materials and Chemical Technologies