Cargando…
Advanced manufacturing and materials /
| Clasificación: | Libro Electrónico |
|---|---|
| Autor Corporativo: | |
| Otros Autores: | |
| Formato: | Electrónico Congresos, conferencias eBook |
| Idioma: | Inglés |
| Publicado: |
Switzerland :
Trans Tech Publications,
2018.
|
| Colección: | Materials science forum ;
v. 939. |
| Temas: | |
| Acceso en línea: | Texto completo |
Tabla de Contenidos:
- Intro; Advanced Manufacturing and Materials; Preface; Table of Contents; Chapter 1: Properties and Processing Technologies of Steel and Alloys; Wear Resistance Improvement of Cold Work Tool Steel by Fine Shot Peening; Precipitation Characterization and Mechanical Behavior in Novel DP Steels; Effect of Nickel Content on Mechanical Property and Microstructure for Sulfide Stress Corrosion High-Strength Steel; Influence of Deep Rolling Process Parameters on Surface Residual Stress of AA7075-T651 Aluminum Alloy Friction Stir Welded Joint
- Effects of Deep Rolling on Surface Residual Stress and Microhardness of JIS SS400 MIG WeldingEffect of Solution Treatment Temperature on Microstructure and Mechanical Properties of Al-5.1Zn-2Mg-0.1Ti (wt. %) Produced by Squeeze Casting; An Empirical Model for Prediction of Residual Stress Based on Grinding Forces; Grain Refinement of Pure Magnesium Using Nonlinear Twist Extrusion; Research on the NC Machining and Simulation for Spiral Bevel Gears of Half-Spread-Out Helix Modified Roll
- Effect of Cold Rolling and Annealing Temperature on the Characteristics of Cu-28Zn-1.1Bi Alloy Produced by Gravity CastingChapter 2: Materials and Processing Technologies in Biomedical Engineering; Investigation on the Anticorrosion Property of the MnCaP Coating on a Mg-Zn-Ca Alloy; Design and Manufacturing of Nasal Conformer; Lithography-Based Ceramic Manufacturing (LCM) for Dental Applications; Microstructure and Characteristic of Biomedical Titanium Alloy Based on Picosecond Laser Micromachining; Chapter 3: Properties and Processing of Functional Materials
- Anodization of Zirconia Nanotubes for Lead (II) AdsorptionFabrication of Energy Materials by a Functional Electrochemical Mold; One-Pot Preparation of Physical Hydrogel-Based Photonic Crystal; Ultra-Sensitive H2S Gas Sensor Based on WO3 Nanocubes with Low Operating Temperature; Submerged Electrical Arc Discharge for Nanoparticles Fabrication Using Carbon-Based Electrodes; Patterned Magnetorheological Elastomer Developed by 3D Printing; Chapter 4: Polymers and Composites; Effect of Type of Fiber on Inter-Layer Bond and Flexural Strengths of Extrusion-Based 3D Printed Geopolymer