Cargando…
Manufacturing process technology : selected, peer reviewed papers from the International Conference on Manufacturing Science and Engineering (ICMSE 2011), April 9-11, 2011, Guilin, P.R. China /
This special volume aims to bring together the latest advances in, and applications of, surface engineering/coatings, modeling, analysis and simulation, materials forming, materials machining, welding and joining, laser-processing technology, casting and solidification, precision manufacturing techn...
| Clasificación: | Libro Electrónico |
|---|---|
| Autor Corporativo: | |
| Otros Autores: | |
| Formato: | Electrónico Congresos, conferencias eBook |
| Idioma: | Inglés |
| Publicado: |
Stafa-Zurich, Switzerland :
Trans Tech Publications,
2011.
|
| Colección: | Advanced materials research ;
v. 189-193. |
| Temas: | |
| Acceso en línea: | Texto completo |
Tabla de Contenidos:
- Manufacturing Process Technology; Sponsors, Committees, Preface; Table of Contents; 1 Surface Engineering / Coatings; Ultrasonic Elliptical Vibration Turning Studty for Precision and Ultra-Precision Workpiece; Experimental Research on Improving Wear Resistance of Coating Surface by Magnetron Sputtering; The Study on Metallurgical Property of 380m3 Blast Furnace Slag of YIGANG; Research in Vacuum Diffusion Bonding of Ti-6Al-4V Alloy and Type 25 Low Carbon Steel; The Influence of Alloying Additives on the Machinability of Austenitic Stainless Steel.
- The Spray Angle Improvement of Single Inlet Pressure Swirl Atomizer Using Partial Structure ModifyingStudy on Friction and Wear Behavior of GCr15/1045 Steel under Nano-Particle Additive Conditions; The Study of Hole Injection in OLEDs with Ultra-Thin Sol-Gel TiO2 Layer; Mass Customization Management in E-Commerce Configuration with early Supplier Involvement; Prediction of 3D Cavity Hydrodynamic Noise Based on Equivalent Source Method; Numerical Simulation of the Effects of Cell Size on the Mechanical Property of Microcellular Polypropylene.
- Sliding Friction and Wear Test of TiAlN TiN Films and 40Cr SteelComputer Simulation on Mo/Al2O3 Solar Energy Selective Absorbing Coating; Effect of Two-Step Deforming and Aging Process on the Properties and Microstructure of Cu-Cr-Zr-Mg-Si Alloy; Effect of Pre-Shot Peening on the Fretting Fatigue Behavior of Plasma Nitrided AISI 420 Stainless Steel at 350 °C; Microstructural Study of Nanostructured ZrO2 Based Thermal Barrier Coatings Fabricated by High Efficiency Supersonic Plasma Spraying; Influencing Factors of AZ31B Sheet Deep Drawing; Preparation of ZrTiN Hard Coating and its Performance.
- Application of Monte Carlo Method in the Measurement Process Design According to next Generation of GPSIntegrated CAD System for Bridges Based on BrIM; Effects of TiO2 on the Viscocity and Solidification Temperature of Mold Fluxes for the Stainless Steel; Contact Analysis for Joint Interfaces of Machine Tools Based on a 3-D Anisotropic Asperity Model; Grinding Performance of Permeated Grinding Wheel; Investigation of the Effects of Dielectric Inlet Pressure in Inner Jetted Dielectric EDM Milling; Research on the Adhesion of Stainless Steel Film on Gd by Magnetron Sputtering.