Cargando…

Compressor handbook : principles and practice /

Annotation

Detalles Bibliográficos
Clasificación:Libro Electrónico
Autor principal: Giampaolo, Tony, 1939-
Formato: Electrónico eBook
Idioma:Inglés
Publicado: Lilburn, GA : Boca Raton, FL : Fairmont Press ; Distributed by Taylor & Francis, ©2010.
©2010
Temas:
Acceso en línea:Texto completo
Tabla de Contenidos:
  • Machine generated contents note: ch. 1 Introduction
  • History
  • ch. 2 General Compressor Theory
  • Thermodynamics of Compression
  • ch. 3 Compressor Types
  • Dynamic Compressors
  • Axial Compressors
  • Centrifugal Compressors
  • Variations in Compressor Design
  • Positive Displacement Compressors
  • Blowers
  • Reciprocating Compressors
  • Preliminary Selection and Sizing
  • Screw Compressors
  • Screw Compressor Control
  • ch. 4 Effect of Operating Conditions
  • Effects of Temperature & Pressure
  • Effects of Compression Ratio
  • Effects of Specific Heat Ratio
  • ch. 5 Throughput Control
  • Speed Control
  • Suction Throttling Control
  • Discharge Valve Throttling Control
  • Recycle Valve Control
  • Variable Volume Pocket Control
  • ch. 6 Description of Surge
  • Surge & Stall
  • ch. 7 Surge Control
  • Minimum Flow Control
  • Maximum Pressure Control
  • Ratio Control
  • ch. 8 Vibration
  • Rotor Response
  • Sources of Vibration
  • ch. 9 Valve Requirements
  • Valve Types.
  • Note continued: Valve Trim
  • ch. 10 Instrument Requirements
  • Sensor Types
  • Speed of Response
  • ch. 11 Detectable Problems
  • Mechanical Problems
  • Electrical Problems
  • Performance Problems
  • ch. 12 Controlling Reciprocatng and Centrifugal Compressors in Identical Processes
  • ch. 13 Optimization & Revitalization of Existing Reciprocating Compression Assets
  • ch. 14 Piston Rod Run-out is a Key Criterion for Recip Compressors
  • ch. 15 Effect of Pulsation Bottle Design on the Performance of a Modern Low-speed Gas Transmission Compressor Piston
  • ch. 16 Resolution of a Compressor Valve Failure: A Case Study
  • Appendix
  • A1.Compressor Manufacturers
  • A2.Comparison of Three Types of Compressors
  • B1. List of Symbols
  • B2. Glossary of Terms
  • B3. Conversion Factors
  • C. Gas Processers Suppliers Association Select Curves & Charts
  • D. Classification of Hazardous Atmospheres
  • E. Air/Oil Cooler Specifications Check List
  • F. Cylinder Displacement Curves.
  • Note continued: G.Compressor Cylinder Lubrication
  • H. Troubleshooting Chart
  • I. Typical Starting, Operating and Maintenance Procedures for a Reciprocating Compressor
  • J. Basic Motor Formulas and Calculations.