Cargando…
Mechanical, thermal and hygric properties of buildings materials : selected, peer reviewed papers from the 1st International Doctoral Conference on Advanced Materials, July 23-25, 2014, Zahrádky, Czech Republic /
This book summarizes selected papers of student conference focused on the study of properties of building materials. Presented papers deal with investigation of materials properties of conventional and also innovative building materials. The knowledge of particular material properties is essentially...
| Clasificación: | Libro Electrónico |
|---|---|
| Autor Corporativo: | |
| Otros Autores: | , , |
| Formato: | Electrónico Congresos, conferencias eBook |
| Idioma: | Inglés |
| Publicado: |
Switzerland :
Trans Tech Publications,
[2014]
|
| Colección: | Advanced materials research ;
v. 982. |
| Temas: | |
| Acceso en línea: | Texto completo |
Tabla de Contenidos:
- Mechanical, Thermal and Hygric Properties of Buildings Materials; Preface, Committee and Acknowledgement; Table of Contents; Analysis of Thermal Conductivity of Lime Plaster with Pozzolanic Addition by Different Homogenization Techniques; Moisture Transport Properties of Hydrophilic Mineral Wool; Application of TDR Method for Moisture Profiles Measurement in Cellular Concrete; Adsorption of Water Vapor in Selected Sandstone Influenced by Different Method of Measurement Using Dynamic Vapor Sorption Device.
- Effect of Porosity on Mechanical and Hygric Properties of Concrete with Natural Pozzolan AdditionEffect of Zeolite Admixture on Freeze/Thaw Resistance of Concrete Exposed to the Dynamic Climatic Conditions; Influence of Casting Direction on the Mechanical Properties of Cementitious Fiber Reinforced Composites; Restrained Shrinkage Test of High Performance Concrete Ring Specimen; Retention Curves of Different Types of Sandstone; Comparison of Two Different Modes of Inverse Analysis Used for Determination of Moisture Diffusivity of Building Materials.
- Determination of Hygric Properties of Hollow Brick Block as a Function of Moisture ContentProduction and Use of the Textile Reinforced Concrete; Moisture Migration in High Strength Concrete; Application of Digital Optical Microscopy in Materials and Mechanical Engineering: Optical Porosimetry and Crack Detection; Mechanical Behavior of the Cement Mortar with High Amount of Municipal Solid Waste Incineration (MSWI) Bottom Ash as an Alternative Aggregate.
- A Comparative Study on Thermal Properties of Two Types of Concrete Containing Fine Ceramic Waste and Burnt Clay Shale as a Supplementary MaterialNumerical Study of the Influence of Internal Blast on the Earth Covered Composite Arch; Heat and Water Vapor Transport Properties of Selected Commercially Produced Plasters; Fracture Surface Measurement of Concrete with Respect to Loading Speed; Thermal Properties of Selected Timbers; Pore Structure and Thermal Characteristics of Clay Bricks; New Type of Lightweight Gypsum-Based Material.
- Residual Strength of Thermally Loaded Mortars with Treated Municipal Solid Waste Incineration Fly Ash Used as Supplementary Cementitious MaterialInfluence of Different Mechanical Properties to the Concrete Penetration Resistance; Influence of High-Temperature on Polycarboxylate Superplasticizer in Aluminous Cement Based Fibre Composites; Development and Mix Design of HPC and UHPFRC; Properties of Cement Composites Containing Coir Pith; Mechanical and Rheological Properties of Aluminous Cement under High Temperatures.