Cargando…
Science and engineering of materials : selected, peer reviewed papers from the 1st International Conference on Science & Engineering of Materials 2013 (ICoSEM 2013), November 13-14, 2013, Kuala Lumpur, Malaysia /
Collection of selected, peer reviewed papers from the 1st International Conference on Science & Engineering of Materials 2013 (ICoSEM 2013), November 13-14, 2013, Kuala Lumpur, Malaysia. The 61 papers are grouped as follows: Chapter 1: Biomaterials; Chapter 2: Catalytic Materials; Chapter 3: Cer...
| Clasificación: | Libro Electrónico |
|---|---|
| Autor Corporativo: | |
| Otros Autores: | , |
| Formato: | Electrónico Congresos, conferencias eBook |
| Idioma: | Inglés |
| Publicado: |
Zurich, Switzerland :
Trans Tech Publications,
[2014]
|
| Colección: | Advanced materials research ;
v. 970. |
| Temas: | |
| Acceso en línea: | Texto completo |
Tabla de Contenidos:
- Science and Engineering of Materials; Preface and Committees; Table of Contents; Chapter 1: Biomaterials; Biomimetic Porosity of Gelatin-Hydroxyapatite Scaffold for Bone Tissue; Removal of Pb (II) by CS2 Modified Kenaf Powder; The Effects of YSZ-Al2O3 Addition on Hydroxyapatite Fabricted by Powder Metallurgy; The Potential of Quercetin in Psidium guajava L. Leaves Extract as Bioinhibitor for Controlled Released Fertilizer; Synthesis and Properties of Biphasic Calcium Phosphate Prepared by Different Methods; Chapter 2: Catalytic Materials
- Decolorization of Methylene Blue by Photocatalyst in the Ag3PO4-AgI SystemChapter 3: Ceramics; Investigation of Ultrasonic Pretreatment on the Synthesis of Zeolite-T and its CO2 Adsorption Characteristics; Sintering Effects on Microstructure and Electrical Properties of (Na0.5K0.5)0.94Li0.06NbO3 Lead-Free Ceramics; Vapochromic Copper (I) Pyrazolate Complex Materials for Phosphorescent Chemosensors of Ethanol; Chapter 4: Coating and Surface Engineering; A Study on Biocompatibility of Gadolinium Based Anodizing Coating AZ91D Magnesium Alloy in Simulated Body Fluid (SBF) Solution
- Characterization of Oxide Film by Vanadium Based Anodic Oxidation CoatingInvestigation of Surface Characteristics of Hydroxyapatite/Titanium Composite Layer Obtained by HF Magnetron Sputtering; Chapter 5: Composites; Basalt Carbon Hybrid Composite for Wind Turbine Rotor Blades: A Short Review; Effect of Maleic Anhydride Grafted Poly(actic acid) on Properties of Sawdust/Poly(lactic acid) Composites Toughened with Poly(butylene adipate-co-terephthalate)
- Effects of Sawdust Content and Alkali Treatment on Mechanical and Flame Retarding Properties of Sawdust/Recycled High Density Polyethylene CompositesElectron Beam Crosslinking of EVA/ENR-50/HNTS Nanocomposites in the Presence of Trimethylol Propane Triacrylate, TMPTA; Quasi-Static Flexural and Indentation Behaviour of Polymer-Metal Laminate; Chapter 6: Electronic and Electronic Packaging; Corrosion Behavior of Soldered and Laser-Welded Ni-Free Co-Cr Alloy Joints in Sodium Chloride Solution
- Deposition of Amorphous Boron Carbide Films with Pulsed Magnetron Sputtering and Evaluation of their Mechanical PropertiesFabrication and Characterization of RF Magnetron Sputtered Silicon Oxide Films; Fabrication Method of Mems Based Clamped-Clamped Resonant Magnetometer; Humidity Sensors on Thermally Oxidized Silicon Substrates; Influence of Spinning Speed on the Properties of Sol-Gel Spin Coated ZnO Films; Microstructural and Electrical Conductivity of Annealed ZnO Thin Films; Preparation and Mechanical Characterization of Amorphous B-C Films