Cargando…
Energy efficient technologies for sustainability : selected, peer reviewed papers from the International Conference on Energy Efficient Technologies for Sustainability (ICEETS 2013), April 10-12, 2013, Tamilnadu, India /
Energy is the major driving force for the economy of any nation. The challenge for continuous generation of power to meet the ever growing demand is a daunting task, especially due to limited resources. This collection of peer reviewed papers contains original research articles in different areas of...
| Clasificación: | Libro Electrónico |
|---|---|
| Autor Corporativo: | |
| Otros Autores: | , , |
| Formato: | Electrónico Congresos, conferencias eBook |
| Idioma: | Inglés |
| Publicado: |
Durnten-Zurich :
Trans Tech Publications,
[2013]
|
| Colección: | Advanced materials research ;
v. 768. |
| Temas: | |
| Acceso en línea: | Texto completo |
Tabla de Contenidos:
- Ch. 1 Utilization of Alternate Energy for Sustainability
- Analysis of Three Port Full Bridge and Half Bridge DC-DC Converter Interfacing Renewable Energy System / R. Ramaprabha
- Comparative Analysis of Solution Methods to Power Electronic Interface Modeling for Renewable Energy Applications / D.P. Kothari
- Investigation of PMSG Fed Diode-Clamped Multilevel Inverter for Wind Energy System / R. Seyezhai
- Modeling of Photovoltaic Array and Simulation of MPPT Algorithm / R. Ramprakash
- A Review of Mathematical Models for Performance Analysis of Hybrid Solar Photovoltaic
- Thermal (PV/T) Air Heating Systems / G. Edison
- Structural Analysis of a Wind Turbine Blade / S. Prakash
- Application of Particle Swarm Optimization Technique for the Design of Maximum Power Point Tracking / N. Rajasekar.
- Application of Wind Energy Source to Large Scale Desalination System Prefeasibility Analysis-Investigation of Wind Power Potential in Coastal Areas of Tamilnadu / V. Rajini
- Performance Analysis of Flat Plate Solar Water Heater by Changing the Heat Pipe Material / S. Balakrishnan
- Effect of Working Pressure on Structural, Electrical and Optical Properties of CIGS Thin Film Deposited by PLD / R. Chandra
- Modelling and Simulation of 3-phase Transformerless Split Inductor Multilevel Inverter for Grid Connected Photovoltaic System / S.S. Dash
- Implementation of a Low Cost Resonant Boost Converter Connected Photo Voltaic System / R. Boga
- Three Phase Hybrid 7-Level Inverter with 60 Degree PWM Scheme for PV Applications / V. Velmurugan
- Performance Studies on Solar Photovoltaic Thermal System for Crop Drying / K. Shekar
- Development of Computational Technique for Better Utilization of Renewable Energy / R. Arulmozhiyal.
- Influence of Source
- Substrate Distance of Cu4SnS4 Thin Films Grown by Co-Evaporation / K.T.R. Reddy
- Simulation and Hardware and Implementation of Directly Coupled Four Phase Interleaved Boost Converter for Fuel Cells / R. Seyezhai
- Development and Field Test Performance of a Non-Conventional Unidirectional Co-Axial Two Series Rotors Micro Wind Turbine / S.N. Sapali
- Maximum Power Point Tracking Based on Look Up Table Approach / R. Ramaprabha
- Sensorless Control of PMSG Wind Turbine Using ANFIS / G. Muruganandam
- Design and Modeling of Photovoltaic System Fed Brushless DC Motor / R. Muthu
- Cost Effective Wind Energy Conversion Scheme Using Self-Excited Induction Generator / S.P. Sabberwal
- Performance Evaluation and Exhaust Emission Analysis of a CI Engine Fuelled with Pongamia Pinnata Biodiesel and its Blends / N. Bose.
- Experimental Analysis of Energy Recovery from an Internal Combustion Engine Exhaust Using Rankine Cycle / P. Seenikannan
- Experimental Investigation of Nano Particles Blended with Water on Solar Flat Plate Collector / R. Balamurugan
- ch. 2 Energy Efficient Automotive Technologies
- Spray Characteristics of Diesel and Biodiesel in Direct Injection Diesel Engine / N. Nallusamy
- Experimental Study on the Spray Characteristics of Diesel and Biodiesel (Jatropha Oil) in a Spray Chamber / N. Nallusamy
- Effect of DEE Injection in Pongamia Pinnata Biodiesel Fulled CI Engine Using Hydrogen as Secondary Fuel / U.P. Vignesh
- Development of Energy Saving and Environment Friendly Aluminum Hybrid Composite Materials for Vehicle Applications / S.S.I. Faiyaz
- Performance Improvement on a Single Cylinder Diesel Engine Powered with Pongamia Biodiesel by Incorporating Swirling Grooves / K. Annamalai.
- Influence of Dual Fuel Twin Injection on Diesel Engine Combustion and Emission Characteristics / R.T.K. Raj
- Mechanical Modifications to Convert Small Two Strokes Carbureted Engine to Electronic Fuel Injection System Engine to Reduce Emission and Fuel Consumption / A.N. Tikekar
- Comparison of Performance and Emission Characteristic of Tamanu, Mahua and Pongamia Biodiesel in a Di Diesel Engine / K. Annamalai
- Numerical Investigations of Spray Droplet Parameters in a Direct Injection Diesel Engine Using 3-Z Extended Coherent Flame Model / R.T.K. Raj
- Analysis and Experimentation of a Three Phase Asymmetric Cascaded Multilevel Inverter for Electric Vehicles / V. Vardhaman
- Investigations on the Effect of Bio Fuel Enhancer Additive with Cashew Nut Shell Liquid Biodiesel Blends on Engine Performance and Pollutant Emissions in a Diesel Engine / S. Ramabalan.
- Performance and Emission Characteristics of Low Heat Rejection Diesel Engine Fuelled with Rice Bran Oil Biodiesel / C. Dhanesh
- Effects of Compression Ratio on Performance and Emission of Internal Combustion Engine with Used Vegetable Oil Methyl Easter / N. Nedunchezhian
- Experimental Studies on Performance and Emission Analysis in Diesel Engine Using Bio-Fuel (Neem Oil) / P. Seenikannan
- ch. 3 Energy Efficient Manufacturing Systems
- Outlook of Indian Household Energy and Emission Profile / S.K. Yawale
- Estimation of Energy and Carbon Saving Potential in Industrial Lighting System / D. Devaraj
- Comparison Studies on Microwave & Muffle Furnace Heat Treatment for Al-B4C Composite / A. Padmanathan
- ch. 4 Improving the Efficiency of Power Systems
- Comparison of Constant Instantaneous Power Control & Synchronous Rotating Frame Strategy for Total Harmonic Reduction in Aircraft System (400Hz) / V.M. Mishra.
- Uncertainty Modelled Power Flow Analysis for DG Sourced Power Systems / D. Poornima
- Mitigation of Power Quality Problems Using DSTATCOM with Reduced DC Link Voltage / S.S. Dash
- Nonlinear Unbalanced Load Compensation for PV Sourced Grid Connected Inverter / M. Jeevitha
- Analysis and Stability Enhancement of DG Sourced Power System with Modified AVR and PSS / C. Birindha
- Harmonic and Power Factor Analysis with Reactor and Capacitor in Adjustable Speed Drive / R. Suganthi
- Optimization Techniques for the Economic Dispatch Problem in Various Generation Plant / A. Allirani
- Mitigation of Power Quality Issues by Adaptive Current Hysteresis Band Controller Based Shunt Active Filter / R. Abirami
- Synthesis and Characterization of PANI/Ferric Chloride Composite for Fabrication of Electrodes in Supercapacitor / M. Govindasamy
- Mitigation of Voltage Sags and Swells by Dynamic Voltage Restorer / D. Devaraj.
- A Novel Control Strategy for DVR to Improve Voltage Profile in Wind Farm / P.C. Babu
- Reliability Improvement in a Radial Distribution System Using DG / M. Sudhakaran
- Speed Control of Induction Motor via Pic Controller Using Lab View / R. Arulmozhiyal
- Optimum Allocation of Distributed Generation Based on Nodal Pricing for Profit and Social Welfare Maximization / S.S. Dash
- Maximum Loss Reduction and Voltage Profile Improvement with Placement of Hybrid Solar-Wind System / M. Sudhakaran
- Transient Stability Improvement with Unified Power Flow Controller Using Fuzzy Logic and ANFIS Approach / C.K. Rani
- Analysis of Full Bridge Series Parallel Resonant Converter for Battery Chargers / S.S. Dash
- Stability Improvement in Power Systems Using Unified Power Flow Controller (UPFC) / J. Michael
- Three Input DC-DC Boost Converter for Hybrid Power System with Multilevel Inverter / R.J. Uthayakumar
- Design and Simulation of Energy Efficient Fixed Frequency Pulse Controlled Power Converter for Induction Melting Application / M. Beryl.